15330 Autoloader ALE: STEP : axis 2 already moving Trendsetter_400/800_Auto First try selecting the RESUME button on the workstation dialog box a few times. If this does not make the problem go away, then remove the plate from the unload table and select the PLATE REMOVED button on the workstation dialog box. If the problem persists, then Creo Service should be called. This error occurs when the stepper motor is currently moving and another command is issued to move the stepper motor. This can occur when the stepper motor is being moved using the diagnostic commands or when the stepper motor has not finished returning to the HOME position at the end of a PROCESS command and an UNLOAD command is issued. If the procedure described in Operator Action does not correct the problem, then the stepper controller must be re-initialized. Do this either by typing TABLE INIT or (if that does not work) resetting the recorder. ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:02 2008 PST